The content is just an excerpt from the complete note for JSS1 Second Term Basic Technology Lesson Note – Uses and Cares of drawing instruments and materials. Check below to download the complete PDF

 WEEK 3:

TOPIC: DRAWING INSTRUMENTS AND MATERIALS

Sub-Topic:

  1. Uses of drawing instruments and materials.
  2. Care of drawing instruments and materials.

Sub-Topic: Uses of drawing instruments and materials

  1. A drawing board is the wooden platform on which the drawing paper is placed before the drawing starts. The two main types are (a) full imperial size which is 812 x 585mm (b) half imperial (585 x 452mm) size.
  2. Tee square is used for drawing horizontal or parallel lines in conjunction with drawing board.
  3. Drawing pencils are of different grades used for general drawing, lettering or freehand sketching and technical or engineering drawing. We have B, 2B, 3B, 4B up to 8B and H, 2H, 3H, 4 H up to 8H pencils.
  4. A Compass: Used for drawing circles and arcs.
  5. A Divider: used for transferring measurement from the metric rule to the drawing.
  6. Set Squares: Are used to draw vertical or diagonal lines.
  7. Drawing Papers: are best held on the boards with the aid of clips or adhesive tape.
  8. The Protractor: is used for measuring and marking out angles.
  9. Drawing paper: This is the paper on which the drawing is produced. The common paper sizes are: A0: 841 * 1189

A1: 594 * 841

A2: 420 * 594

A3: 297 * 420

A4: 210 * 297

To gain full access to the note: DOWNLOAD FILE

Copyright warnings! Do not copy.