State FIVE safety precautions on milling machine. – NABTEB QUESTION

By: |Published on: Oct 3|Categories: NABTEB QUESTIONS| 0 comments

Five safety precaution on a milling machine

(i) Tool should rigidly held in the arbor

(ii) The arbor must be supported with arbor supporting bracket

(iii) Work must be rigidly held in the machine vice

(iv) Over hanging of the tool must be avoided

(v) Do not take measure while the machine is in operation

(vi) When holding job directly on the machine table, parallel, tee bolts washes, nuts and clamps must be tightened very well.

Users Also Read These:

SEE ALSO  Explain briefly the following terms using an example to illustrate each. i. Atomic mass number ii. Nuclear charge iii. Valency iv. Isotopy. - NABTEB QUESTION

Copyright warnings! Do not copy.