JSS1 Third Term Basic Technology Lesson Note – Driving Tools

The content is just an excerpt from the complete note for JSS1 Third Term Basic Technology Lesson Note – Driving Tools. Check below to download the complete PDF

 WEEK 6

SUB-TOPIC: DRIVING TOOLS

These are tools used for pushing in nails, screws into position. Examples are:

• HAMMERS: have two distinct parts, the handle and the head. While the handle can be made of wood or metallic material, the head is always made of high carbon steel. The hammer is classified according to the type of head, hence we have:

Ball peen, straight peen, cross peen and planishing hammer.

• MALLETS: this is a soft hammer whose head is made of soft material like synthetic rubber to prevent the head from damaging the surface of the work piece.
• PUNCHES: These are used for producing holes on thin sheets of metal, to mark holes for drilling and to remove rivet. Examples are: centre or dot punch, and pin punch for marking drill points.

To gain full access to the note: DOWNLOAD FILE